Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: gary on June 24, 2006, 01:16:34 PM

Title: Roughing paths
Post by: gary on June 24, 2006, 01:16:34 PM

Hello is there any part of the mach programs that will work a roughing path out for lathe after a dxf drawing has been imported.
cheers Gary

Title: Re: Roughing paths
Post by: Brian Barker on June 24, 2006, 05:06:28 PM

Not at this point :( in the next year or so we will be making some tools for the lathe :)