Machsupport Forum
Mach Discussion => Feature Requests => Topic started by: ftomazz on September 19, 2008, 09:23:17 AM
-
It should be possible to have constant surface speed without spindle feedback (turning mode).
If I consider that the real speed is equal to the spindle speed set up by mach, CSS should work.
In fact there is an option in the ports&pins -> spindle setup -> special functions
that have: Use spindle feedback in sync modes
If it is unchecked, it should do exactly what I mean, but it does not work, still expects the feedback.
Also this should be very easy to implement.
Filipe