Machsupport Forum

Mach Discussion => FAQs => Topic started by: apollonono on September 05, 2008, 08:26:22 AM

Title: It is a question about application of MACH3.
Post by: apollonono on September 05, 2008, 08:26:22 AM

Is there the most suitable panel to operate four axis form heat rays cutters?

Title: Re: It is a question about application of MACH3.
Post by: lpz on May 21, 2009, 11:24:08 PM

Folks:
I have s/w that creates the g-code to work in an x,y direction. Is there a way for me to make the g-code cut in a 45degree path?

Thanks in advance
LZ