Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: turmite on June 09, 2006, 01:48:00 PM
-
Is there anyone that can give a comparison between 2 and 3 digitizing
wizards? I have discovered a major bug in v2 and I know that Art and
Brian would much rather spend their time on finishing v3. So with that
in mind, I may have to change to v3 now if the wizard is better.
I set up a part, opened the wizard input all the info which was a .125"
step in the x and a .06 step in the y. When doing the first line the x
would somtimes jog 1 step, or 2 or 3 or 10. It was never consistant and
sure not good enough to get a usable file from.
Any ideas?
Mike
ps when doing multiple steps in the x axis the dro was reading the correct movement.