Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: rqlaser on August 21, 2008, 12:58:19 PM

Title: New User - Need Post Processor Guidance -
Post by: rqlaser on August 21, 2008, 12:58:19 PM

Just installed EZ-Router with MACH3 and V-Carve. Everyone is telling me that I need to setup post processor(s). Anyone no how these need to be setup??  ???

Title: Re: New User - Need Post Processor Guidance -
Post by: Hood on August 21, 2008, 05:58:00 PM

Should be in the config of your V-Carve, you will probably get a choice of which post processor to use.
Hood

Title: Re: New User - Need Post Processor Guidance -
Post by: ger21 on August 21, 2008, 09:42:02 PM

Nothing to set up. Just pick the appropriate Mach3 post to use, usually the arc ones, metric or inch.