Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: DennisCNC on August 16, 2008, 01:53:30 PM
-
I added another screen in mach with a X dro, it updates fine if I jog in the run program screen but will not jog in the new screen I made. What needs to be done to make it jog?
-
Hi Dennis, I found that if I had the JOG ON/OFF button set to display on all screens, I couldn't actually jog.
So I just had to add the button to all screens instead ..... voila...
-
Thank you much would have taken me years to figure that out, works good now.
Thanks