Machsupport Forum

G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: luv2c_cnc on June 26, 2008, 12:43:44 PM

Title: Press "S" for "rat" Is there a way to slow down the "rat"?
Post by: luv2c_cnc on June 26, 2008, 12:43:44 PM

Once a cut path is plotted, pressing the "S" key activates the "rat", a small blob that follows the cut paths.  Problem is, on a simple 2d cut like a rectangle, the rat goes so incredibly fast, one cannot tell if the cut path and those of nearby entities is / are correct. is there a keystroke(s) that will control the rat's speed?

Thanks Luv2cCNC

Title: Re: Press "S" for "rat" Is there a way to slow down the "rat"?
Post by: budman68 on June 26, 2008, 03:10:57 PM

I believe I asked this once before and the answer was no. I would like that too-

 Sorry -   :-\

Title: Re: Press "S" for "rat" Is there a way to slow down the "rat"?
Post by: Glenn on June 28, 2008, 07:54:24 PM

Hey luv2c_cnc,
  Thanks for the info on the rat... I didn't even know it existed! I ran mine over a text font, and it seems to work,kind of fast, but how do you stop it once you start it?
I had to hit cont, alt,  delete, just to make the rat stop!
  Just wondering where you got the info, I've read many tutorials I must have glazed over this one ;)

 Thanks, Glenn

Title: Re: Press "S" for "rat" Is there a way to slow down the "rat"?
Post by: Glenn on June 28, 2008, 07:56:53 PM

Hit "s" again, and it stops! ;D
Glenn