Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: tubular2000 on May 17, 2006, 09:55:16 AM

Title: I/O
Post by: tubular2000 on May 17, 2006, 09:55:16 AM

is it possible to use mach3 with something else than the parralel port? like these 96 I/O card that are available with breakout board and analog outputs.

Title: Re: I/O
Post by: Brian Barker on May 17, 2006, 10:01:43 PM

The only other thing is the G100 from GeckoDrive.com . This is run by Mach4 and should be released in a few months...