Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Graham Waterworth on May 17, 2006, 03:53:47 AM

Title: Tool offsets table
Post by: Graham Waterworth on May 17, 2006, 03:53:47 AM

Hi All,

is there a VB command in Mach3 Turn to read the contents of a tools offset data ?

Thanks

Graham.

Title: Re: Tool offsets table
Post by: Brian Barker on May 17, 2006, 09:59:55 PM

No not at this time :(