Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: KNS Supply on March 28, 2008, 09:21:40 PM

Title: I need a wiring diagram for a breakout board from cnc4pc
Post by: KNS Supply on March 28, 2008, 09:21:40 PM

Hi all,
I have a  breakout board from cnc4pc and need a wiring diagram for it.
this guy Arturo Duncan that owns the company never gets back to me.
It's a c10 board and its revision #3
I need to use this one until PMDX gets the one built that supports the new
gecko 203v drives that are going on the machine.
Thanks,
Brian

Title: Re: I need a wiring diagram for a breakout board from cnc4pc
Post by: poppabear on March 28, 2008, 10:09:06 PM

What do you mean??  His site has PDF docs that you can download the explain what your asking.
It covers jumper settings for using the bi-directional state, and a jumper for changing your common polarity.

Your hot +5v, has to have a jumper to the Enable right next to it.

scott

Title: Re: I need a wiring diagram for a breakout board from cnc4pc
Post by: KNS Supply on March 28, 2008, 11:14:00 PM

Yea the pdf doc is for rev 8, mine is rev 3: which is really similar but I just wanted a diagram for that model to be sure.

Title: Re: I need a wiring diagram for a breakout board from cnc4pc
Post by: Overloaded on March 29, 2008, 01:42:12 AM

Hey Brian,
You might check here.
http://machmotion.com/pdf/Breakout%20Board%20Manuals.pdf
It's too big to dnld. here......24k, sad.
RC