Machsupport Forum

Mach Discussion => VB and the development of wizards => Topic started by: rceebuilder on March 26, 2008, 09:33:31 PM

Title: How does the system wait for spindle reach full speed.
Post by: rceebuilder on March 26, 2008, 09:33:31 PM

My spindle  needs some time to reach full speed  So the axis movements should  wait for a while. How can I  do it by a macro?

Rceebuilder

Title: Re: How does the system wait for spindle reach full speed.
Post by: vmax549 on March 26, 2008, 10:07:17 PM

you could do it by macro but you moght want to try the spindle delay settings you can set spinup and down cw and ccw. Or just set a g4pXX setting after the m3 and before the next g movement.

(;-) TP

Title: Re: How does the system wait for spindle reach full speed.
Post by: Bodini on March 27, 2008, 12:18:29 AM

It's built in.  Mach>config>ports and pins>spindle setup (tab)>general parameters section.