Machsupport Forum

Support => Forum suggestions and report forum problems. => Topic started by: petervanleemput on March 12, 2008, 05:49:56 AM

Title: LazyCam G-Code
Post by: petervanleemput on March 12, 2008, 05:49:56 AM

I get error message with G3 radius "center wrong". Solution?

Title: Re: LazyCam G-Code
Post by: Tweakie.CNC on March 12, 2008, 07:39:20 AM

Hi,

I have used Lazy Cam 2.00.060 to create the G-Code from your DXF.  Running this code with Mach3 R1.84.000 I have no problems.

I attach the G-Code for you to try.

Good luck,

Tweakie.

Title: Re: LazyCam G-Code
Post by: Sam on March 12, 2008, 10:56:06 AM

Could be that your "I-J mode" is set opposite of what it should be. In Mach3, go to config tab>general config. I-J mode is listed in the middle of the page.