Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: mirkolinux on May 02, 2006, 04:36:32 PM

Title: Mach 4, G-Rex and linear encoders...
Post by: mirkolinux on May 02, 2006, 04:36:32 PM

Hi, i have a question..... ;D

I have a g100, 3 servo, and 3 linear encoders, i use mach 4 in metric units, but what is the optimal motor tuning config for my system?
I have set same of the tutorial, but the value of encoders it does not come considered in the movements of the system.....  Why? is it correct ?
Thanks and hello to all!

p.s. sorry for my bad english... ::)

Title: Re: Mach 4, G-Rex and linear encoders...
Post by: Brian Barker on May 02, 2006, 06:42:53 PM

That part of the firmware has not been writen into the G100. I don't know when Steve H. will start to code that in.

Thank you
Brian