Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Whacko on February 13, 2008, 02:49:29 PM

Title: Dwell interupt
Post by: Whacko on February 13, 2008, 02:49:29 PM

I'm sort of back on the forum. Got injured in a botched hijacking. The only good thing about it is the hijacker got of worse than me! Anyway, a question, is there a way of interupting an active G4P thread? With other words, while in the G4 dwell cycle, can it be stopped before timing out?

Whacko

Title: Re: Dwell interupt
Post by: Overloaded on February 13, 2008, 03:21:25 PM

Hello Whacko, glad to hear you're OK.
Kind of missed you since the holidays. Been kind of slow around here.
Anyway..I've noticed that hitting the cycle start interrupts the dwell and resumes the program run.
I guess it could be done with a brain or macro, just trigger the cycle start.
Good luck,
RC

Title: Re: Dwell interupt
Post by: zealous on February 13, 2008, 09:16:02 PM

hey Whacko,
Where you in Johannesburg with your girlfriend? I read about it in the news, but it might have been a diffrent story.

Title: Re: Dwell interupt
Post by: Whacko on February 15, 2008, 03:52:37 PM

Hi Zealous,

Wasn't me, I'm in Cape Town. There were two of em, jumped me as I got out the car. This country is becoming a health risk!

Whacko