Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: tbriggs on December 30, 2007, 09:24:12 PM

Title: Griffin PowerMate
Post by: tbriggs on December 30, 2007, 09:24:12 PM

I just purchased one of the Griffin PowerMates.  I downloaded the plugin.  Since I am kind of new to this I have a couple of questions.  Do I need to install the PowerMate software and configure anything for Mach3?

When I press the top of the device it toggles between the available axis but nothing happens when I turn the knob.

Am I missing something?

Thanks!

 ???

Title: Re: Griffin PowerMate
Post by: Hood on December 31, 2007, 03:19:38 AM

Dont have one so have never looked at the plugin but maybe you have to go into the plugin and set it up? You may find a config page for it from the operator menu.
Hood