Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: Teknoguy on December 17, 2007, 11:15:43 PM

Title: Phoenix CNC Lathe and Router from Magnum Technogies
Post by: Teknoguy on December 17, 2007, 11:15:43 PM

I have downloaded Mach3 and installed it on both of these machines but can't seem to get anything working. I am wondering if anyone has ever heard of them or possibly set one up already. Sure would be great to get them up and working again.

Title: Re: Phoenix CNC Lathe and Router from Magnum Technogies
Post by: DennisCNC on December 28, 2007, 04:20:01 PM

Lets start from the beginning, do you know what type of motors the machines have (servo, stepper)?  What type of drives for the motors?  Pictures will make this faster.

Title: Re: Phoenix CNC Lathe and Router from Magnum Technogies
Post by: BobJr on June 17, 2014, 05:28:06 PM

Teknoguy
Did you ever make any progress on this quest?
I made a successful switch with my Phoenix router to Mach3 about 6 months ago.
Bob