Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: bpmufx on April 19, 2006, 12:54:32 AM

Title: Post processors
Post by: bpmufx on April 19, 2006, 12:54:32 AM

Hi all,

Can someone set me straight? I think I'm missing something. Where is the info regarding a post processor.
Is there one needed? I don't see any reference to posts in the Mach2.611 pdf.
I also don't see any posts in the Mach folder.
There is almost no querries here in this forrum except a couple of folks asking for the same thing.

What am I missing??

I don't have a Mach2 post in my Mastecam disk, or in my BobCAD disk.
Where are they coming from? ???

Thanks in advance

Evan

Title: Re: Post processors
Post by: Graham Waterworth on April 19, 2006, 03:48:02 AM

Hi,

go to the main Artsoft website, click on downloads, then on FTP, login using your email address, then go to mach3 then post processors, you will then see the mastercam PP.

Graham.

Title: Re: Post processors
Post by: bpmufx on April 20, 2006, 02:05:16 PM

Thanks Graham,
Just what I was looking for.