Machsupport Forum
Third party software and hardware support forums. => Vistacnc Control Pendants => Topic started by: Braith on October 26, 2026, 05:03:40 AM
-
Hi,
Really enjoying using our new VistaCNC P4-s pendant, so much more usable & precise than any others I've seen or heard about.
I'm chasing some eccentric behaviour of our VistaCNC P4-S pendant when connected to our Omio X8 2200l-USB
I'd really like to briefly chat to anyone running a similar system to see if others are getting the same minor quirks.
Mainly interested in setups where where the computer running Mach3 communicates with the Omio via USB