Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: Holzwurm56 on August 31, 2026, 12:40:45 PM

Title: Help Connection from PoKeys57E to PC?
Post by: Holzwurm56 on August 31, 2026, 12:40:45 PM

Hello,
I want to control my lathe using Mach3 and a PoKeys57E board, running on Windows XP. The PoKeys unit is supposed to be connected directly to the PC. Unfortunately, I cannot establish a connection between the board and the PC. I am currently using a standard patch cable; could it be that a crossover cable is required for this connection?
Best regards,
Hans

Title: Re: Help Connection from PoKeys57E to PC?
Post by: Tweakie.CNC on September 01, 2026, 12:38:55 AM

You do not need a crossover cable.
You do need to check that .net framework 3.5 is installed and enabled for configuration of the 57e.
You need to set the correct IP address etc.

Hope this helps,

Tweakie.