Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: patton on March 30, 2026, 10:19:43 AM

Title: Mach4 keyboard inputs
Post by: patton on March 30, 2026, 10:19:43 AM

Hey Everyone, Iv'e been trying to figure out how to make keyboard inputs work with buttons like Block Delete, Optional Stop, and setting Z Zero. This is for a lathe... I tried doing it the same way as Feed Hold, or Cycle Start but It's not working. I would think that it's possible to do this but I'm just not a programmer. Iv'e searched the forum for this but haven't found anything helpful. If anyone can help me figure this out, I would greatly appreciate it.

Thanks
Dave