Machsupport Forum
Support => Downloads => Post Processors => Topic started by: Starfire2038 on December 26, 2025, 11:41:15 PM
-
Hello everyone, I'm using latest Vcarve Pro to Mach4. I have a laser wrapped post processor that appears to be working for the most part. There is one minor issue with the A axis. In Vcarve the job size is L=3.0 and D=.6 ( D is the diameter of the roller so I can do calibration) Placed a rectangle with the measurements of Width = .5 and Height = 1.885 to go around the roller. In 3D view it looks correct. Use my post processor and it somehow changes the A axis value to a much higher number. ( G1A360.7538 ). See attached file.
I would greatly appreciate if someone could point me in the right direction on the post processor file to edit and correct this issue.