Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Mark21 on December 08, 2025, 12:47:19 PM
-
Hello i Have a VFD YL-620-A 110v 20A with a 2.2kw air cooled spindle 110v 12A 2 pole 400hz.
I Connect all the wire (10-VI1-GND on the VFD to 10V-AVI-ACM on the Mach 3 Red Board)
The spindle start the right direction, but when i start M3S12000, I only have a 150hz on the vfd panel and 3.9 volt between the AVI and ACM and with M3S24000 I have a 297hz and 7.6 volt between the AVI and ACM.
How can I set the parameters to obtain my 200hz 5volt with M3S12000 and my 400hz 10 volt with M3S24000 ?