Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: eqrico2017 on September 29, 2025, 06:27:15 PM

Title: Tangential Cut
Post by: eqrico2017 on September 29, 2025, 06:27:15 PM

I need to setup MACH 4 for tangential cut.
Does MACH 4 for Hobbyist version include this option?
 Thank You,
EQ

Title: Re: Tangential Cut
Post by: Steve Stallings on September 29, 2025, 09:18:01 PM

Yes, tangential is supported in Mach 4.

Go to the screen for:  Configure > Control  and select the Defaults tab.

Then look down the left side of the screen, the second block is a setting for "Control Mode".

In the drop down list for Control Mode you will find the option for Tangential.