Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Adam_M on September 13, 2025, 11:22:39 AM

Title: Mach 3 / ESS Smooth stepper / 2010 Screenset - homing issue?
Post by: Adam_M on September 13, 2025, 11:22:39 AM

Just finished installing ESS Smoothstepper and I'm having a problem getting Mach 3 to "Home" with the 2010 Screenset. Machine will home correctly when using the 1024 Screenset...  so it's like all of the homing options are dead on the 2010 screenset, anyone have any suggestions???

Hoping someone has run into this before...

Adam_m,

Title: Re: Mach 3 / ESS Smooth stepper / 2010 Screenset - homing issue?
Post by: Tweakie.CNC on September 14, 2025, 02:21:00 AM

Sounds like you have not installed the macro's ?

The 2010 manual is here;  http://www.thecncwoodworker.com/downloads/mach3/2010%20Manual.pdf

Tweakie.

Title: Re: Mach 3 / ESS Smooth stepper / 2010 Screenset - homing issue?
Post by: Adam_M on September 14, 2025, 09:03:22 AM

Spot on!!!

Many thanks... it had been so long since I initially installed the screenset I forgot there were setup instructions.

Happy CNC'ing!

Adam_M,