Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Graffy on August 18, 2025, 12:14:25 PM
-
When viewing the Input Signals/Output Signals area of the Mach3 Diagnostics screen, when jogging X, Y, or Z axis, will I see activity in any of those indicator lights?
Output 1 illuminates when Spindle is toggled. But nothing happens when jogging the steppers. (The current position counts up/down, but nothing on the Input/Output Signals.
Still trying to determine if my Mach3 setup is wrong or if I have a bad controller board. Spindle runs, steppers won't move.
Thanks.