Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: carmeljc on January 21, 2025, 11:39:47 AM

Title: Method to Track Total Movement of Bit (Maintenance Statistics)
Post by: carmeljc on January 21, 2025, 11:39:47 AM

Hello,

I just updated to Mach4 from Mach3 and am realizing that there's no Maintenance Statistics under the "Operator" tab like in Mach3. Is there anywhere I can still see total operating time and total distance the bit has travelled similar to how Mach3 had it set up? Does anyone know if there's any way or any where to find information remotely resembling this anymore?

Thanks

Title: Re: Method to Track Total Movement of Bit (Maintenance Statistics)
Post by: carmeljc on January 22, 2025, 02:56:52 PM

This is a picture of what was shown in Mach3. Anything like this anywhere in Mach4? I'm just using it know when I "should" replace my bit using some level of data.

Thanks again everyone!