Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: millerdj53 on November 20, 2007, 11:00:34 AM

Title: New Mach User - Strange Code Load
Post by: millerdj53 on November 20, 2007, 11:00:34 AM

Hello all - new user of Mach here.  Recently used OneCNC with Mach post processor for profile code.  Upon loading code, the Mach view of profile (and offline sim) had many additional and large radii that were not desired.  I RePosted and reloaded then ok, but upon reloading the additional radii appeared again, as if it was corrupted.  What am I doing wrong?   Thanks for your help in advance.

Title: Re: New Mach User - Strange Code Load
Post by: Graham Waterworth on November 21, 2007, 04:35:33 AM

Go to General config in mach, swap "IJ Mode" and try your code again.

Graham.