Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Bobbymost on October 31, 2024, 07:23:03 AM

Title: Motor wont fire up unless i reboot the machine
Post by: Bobbymost on October 31, 2024, 07:23:03 AM

My machine will run its G CODE then come back home position. If i want to change G Code to do another cut it wont restart up unless i power down, un plug, wait 2 mins then fire up again and Zero the machine again. Occasionally i will start but not often.

Does anyone else have this issue and if so what can i do to correct it?