Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ironman123 on October 27, 2024, 08:45:06 PM

Title: Curve on end of 1/2 inch round bar
Post by: ironman123 on October 27, 2024, 08:45:06 PM

Hi again.  I am trying to get a curve on the end of some half inch diameter round bar.  I may have something wrong in my code.  Any help or advice would be appreciated.
I drew the arc in TC2020 and saved it as a DXF.  Ran it in Lazy CAM and it produced the G-Code.  I tweaked the code some.  May be wrong.

Title: Re: Curve on end of 1/2 inch round bar
Post by: Graham Waterworth on October 28, 2024, 09:37:20 AM

Try the free built in turn wizards.

Title: Re: Curve on end of 1/2 inch round bar
Post by: ironman123 on October 28, 2024, 07:41:06 PM

Good suggestion Graham.  I forgot all about the wizards.  Thanks.

Ray