Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Rimmel on October 23, 2024, 08:51:05 AM

Title: Is there any way to change the highlight position in the G-Code window?
Post by: Rimmel on October 23, 2024, 08:51:05 AM

Is there any way to change the highlight position in the G-Code window?

At present the highlight stays on the next line to be executed. I would prefer it to be on the currently executed line.

thanks

Title: Re: Is there any way to change the highlight position in the G-Code window?
Post by: cncmagic on October 31, 2024, 11:41:48 PM

just so you don't feel no one cares about your post.. its been asked somewhere else in the forum previously and the short answer is no, you can't. and before I forget.. no one actually cares..  ???

Title: Re: Is there any way to change the highlight position in the G-Code window?
Post by: Rimmel on November 01, 2024, 05:16:28 AM

Quote from: cncmagic on October 31, 2024, 11:41:48 PM

just so you don't feel no one cares about your post.. its been asked somewhere else in the forum previously and the short answer is no, you can't. and before I forget.. no one actually cares..  ???

If someone else has already asked - then someone... somewhere... actually cares  ;)

thanks anyway   

Title: Re: Is there any way to change the highlight position in the G-Code window?
Post by: cncmagic on November 02, 2024, 12:23:32 PM

it wasn't meant that way.. obviously if someone has taken the time and effort to answer your post he/she/it cares.. the forum is here because we do care.. sometimes it doesn't always feel that way. I certainly have been helped on occasion by the members here. And I certainly do believe the members care about answering the questions or concerns asked here.  :o

Title: Re: Is there any way to change the highlight position in the G-Code window?
Post by: Rimmel on November 02, 2024, 01:14:30 PM

Quote from: cncmagic on November 02, 2024, 12:23:32 PM

it wasn't meant that way.. obviously if someone has taken the time and effort to answer your post he/she/it cares.. the forum is here because we do care.. sometimes it doesn't always feel that way. I certainly have been helped on occasion by the members here. And I certainly do believe the members care about answering the questions or concerns asked here.  :o

My reply wasn't mean't as a jibe - just a bit of light humour  ;D

thanks