Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: ROTM on April 19, 2024, 04:30:59 PM

Title: set Plasma z height after cut is finalized Mach4
Post by: ROTM on April 19, 2024, 04:30:59 PM

Good day.
On my router after finish of the cut it will go to x0,y0 and the z 0.8"

On my plasma between the cuts the z will raise to whatever z height I set in Mach4. But a the end of the program it will raise the z all the way up. I am trying to set the same as the router but I cannot find where to set this.

I am using sheetcam for the plasma.

Anyone might know where to set this?

Thank you!