Machsupport Forum
General CNC Chat => Building or Buying a Wood routing table.. Beginnners guide.. => Topic started by: GerryW on April 18, 2024, 09:47:17 AM
-
I'm a real newbie and am building a CNC router. I just completed the build process and am running my first job. It did not go well. But that's another story. Right now I'm trying to figure why my M2++ limit light won't go out? I used 'Manual OverRide Limit' in Settings to move all the axis incase they were touching limit switches. Light stays on. I finally unwired the limit switches from controller card and hooked up a temp limit switch that's attached to no axis. The temp limit switch works but still the light won't go out. Any thoughts in what I did wrong?