Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: metricthread on February 22, 2024, 09:33:29 PM

Title: running two mach3 on two different modules
Post by: metricthread on February 22, 2024, 09:33:29 PM

Hi is it possible to run mach 3 turn with RnR eco-v2.0 controller and run mill with warp9 on same pc without any problems

Title: Re: running two mach3 on two different modules
Post by: JohnHaine on February 23, 2024, 03:12:24 AM

As long as you don't try to run concurrently no problem.  You just have 2 profiles one for lathe and one for mill.  I've done it for years.