Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: ShadyOaks on February 02, 2024, 10:42:34 AM

Title: Rotary Problem
Post by: ShadyOaks on February 02, 2024, 10:42:34 AM

I am using Aspire with a CNC4bie machine and Mach4. I have my A set to angular in Mach4 The Render from Vectric shows about 2.5 revolutions but when I cut it is about a half of a revolution. Also when cutting the coves on each end machine goes to left and makes one down cut and never rotates the A (shown in 1 of the photos attached). I'm at a loss on what's going on. Have atached photos of Vectric rending and what I end up with. When rotating with Gcode the chuck rotates 360 degrees.Thanks for any help.

Title: Re: Rotary Problem
Post by: ShadyOaks on February 03, 2024, 04:23:57 PM

Found the problem. In Mach4 under general do not have check box under Rotary Axes rollover. this solve problem and functions as Mach3 does.