Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MrWilson on January 31, 2024, 06:02:14 PM
-
Hi,
Hey GREAT mach3 users,
Is there a touch probe that plugs into the USB port and
works? (I use UC100 with small DIY router I built running windows 10 64 bit) GX540 drive touch is hard wired.No
Version 3.04.066 upgrade, It works great for Zaxis. but no x/y surface probing.
On the big router I have Z touch, going thur pendant then dongle then USB and plugs into
port works great. (BIG BUCKS SPENT)
I bought Crafety's probe years ago, didn't read the manual close enough, It needs version3.04.066 higher
just to work. doesn't work off USB ( that I know of ).
Not wanting to upgrade yet, ( might have too anyways) not wanting to spend the big bucks.
GREAT HELP MAKES GREAT POSSIBLITYS
Mr Wilson