Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: lordyan on April 13, 2006, 03:37:27 AM

Title: Upload firmaware
Post by: lordyan on April 13, 2006, 03:37:27 AM

Hello,

First excuse me for my bad English.

I have a G-rex with gecko motion firmware.
When I connect the G-rex to my computer with crossover cable, it looks like if i have no cable connected.
The result of ipconfig /all : not connected.

I try with standard cable with router/switch and it is the same.

Someone can help me?

Thanks.

Title: Re: Upload firmaware
Post by: Brian Barker on April 13, 2006, 07:51:41 PM

Can you set a static IP on your computer and try that?

Title: Re: Upload firmaware
Post by: lordyan on April 18, 2006, 03:55:49 AM

Hello,

I try to define a static IP, but it is the same.

Title: Re: Upload firmaware
Post by: Brian Barker on April 18, 2006, 06:53:14 PM

I have to let mine set for about 20 Sec then I can hook up to it... How long do you let it set for?

Title: Re: Upload firmaware
Post by: ART on April 24, 2006, 10:38:03 PM

>> gecko motion firmware

 Geckomotion formware will not talk via tcp , I believe it is for USB only, and not with MAchIV..

Art

Title: Re: Upload firmaware
Post by: ART on April 24, 2006, 10:38:53 PM

Sorry, hit reply too quick. If you have the geckomotion loaded, you need to reflash it with MachIV firmware to see it on TCP from Gloader I think..

Art