Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: STEVE@THECAREYFARM on November 27, 2023, 10:04:31 PM

Title: UC100 ISSUE
Post by: STEVE@THECAREYFARM on November 27, 2023, 10:04:31 PM

I am getting an emergency flash in the Diagnostic tab and cannot reset
i have blue and green light on the uc100
anyone seen this before

Title: Re: UC100 ISSUE
Post by: Tweakie.CNC on November 28, 2023, 12:25:58 AM

What message do you get in the Status bar on the main screen ?

Title: Re: UC100 ISSUE
Post by: STEVE@THECAREYFARM on November 28, 2023, 09:29:22 AM

it is blank

Title: Re: UC100 ISSUE
Post by: Tweakie.CNC on November 28, 2023, 09:55:19 AM

In Config. / Ports & Pins / Input Signals - check EStop is enabled, if so toggle the Active Low state. Does this solve the issue ?