Machsupport Forum
Mach Discussion => Mach3 under Vista => Topic started by: sparkinho on November 14, 2023, 01:27:47 PM
-
my jog works normal all axles, when I weigh the zero or squeegee a gcode no motor works they all lock (it tries to go but they won't keep vibrating the axle) and don't rotate
-
my jog works normal all axles, when I weigh the zero or squeegee a gcode no motor works they all lock (it tries to go but they won't keep vibrating the axle) and don't rotate
Mechanical issues like binding in the axes or excessive friction can cause motors to stall when under heavier load. Check for any obstructions, tight belts, or misaligned components on the carriages and guide rails. Lubricate moving parts if needed.
-
try to reduce velocity and acceleration in Motor Tuning
-
Did you solve the problem?
-
my jog works normal all axles, when I weigh the zero or squeegee a gcode no motor works they all lock (it tries to go but they won't keep vibrating the axle) and don't rotate
Sounds like your motors are getting stuck when under load or when running a G-code. Might be a current setting, firmware, or wiring issue. Check motor drivers, firmware configs, and make sure your G-code isn’t sending invalid moves.