Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: abex49 on November 02, 2023, 09:50:51 AM

Title: zero X, Y, Z using a probe
Post by: abex49 on November 02, 2023, 09:50:51 AM

Has anyone set up thier machine to zero out the x,y,z axis using a probe and an edge finder?

I want to set up the machine to be able to zero out without having to get close to the machine since i have safety mats around the machine and want them to act as an estop.

Any help would be appreciated.

Thanks!

Title: Re: zero X, Y, Z using a probe
Post by: abex49 on November 02, 2023, 10:15:14 AM

This is on the HI-con 7766