Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Shelly on October 25, 2023, 12:48:42 AM

Title: Mach3 problem , using High Z T1000 router
Post by: Shelly on October 25, 2023, 12:48:42 AM

Hi I’m hoping you can help? I have just hooked up my High-z- T1000 to Mach3 . Its moves very well and carves 3d. All axis running in a spiral pattern . This moves x,y,z at the same time.
My problem is with the home and limit switchs on the original machine.( magnetic). Under diagnostics screen , each  switch  when triggered , is seen by Mach3 and the light toggles as it should, but mach 3 will not datum to zero, just runs paste the limit switch?can anyone help please?

Title: Re: Mach3 problem , using High Z T1000 router
Post by: TPS on November 29, 2023, 01:27:03 PM

for the X-axis you see the M1Home Led toogling in the diagnostic screen?
witch motion controller?

Title: Re: Mach3 problem , using High Z T1000 router
Post by: Graham Waterworth on November 29, 2023, 06:40:51 PM

As a test turn of the limit switches in ports and pins and then try to home.