Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ghalib1399 on August 16, 2023, 06:08:53 AM
-
I followed all steps on this video (https://youtu.be/ehlgOhsmGAI), but when it try to run spindle from MACH3 it always run a high speed witch is I put on PD073, and I can decreasing it.
can any one help me with that?
-
I followed all steps on this video (https://youtu.be/ehlgOhsmGAI), but when it try to run spindle from MACH3 it always run a high speed witch is Iangry gran (https://angry-gran.com)put on PD073, and I can decreasing it.
can any one help me with that?
I used Mach3 V3.041 with a Smooth Stepper in PWM mode and the spindle override always started at a slightly higher speed than requested. Then, I pressed “Reset” under the Spindle Speed Tab and it worked. It brought the speed back to the correct requested speed. You can try this way.
-
I followed all steps on this video (https://youtu.be/ehlgOhsmGAI), but when it try to run spindle from MACH3 it always run a high speed witch is I put on PD073, and I can decreasing it.
can any one help me with that?
Without more information on your hardware set-up and system configuration it's very hard to diagnose any problem!