Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: DerekJ on July 12, 2023, 06:04:14 AM

Title: Drive stepper continuously on M07
Post by: DerekJ on July 12, 2023, 06:04:14 AM

Hi,
I’m using MACH4 with a PoKeys57CNC board and trying to set up a stepper motor as a pump to feed my mist cooling system.
I need to get the stepper, connected as Motor3, to run continuously on the M07 command but can’t see a way to do this directly without using an external motor controller triggered from an output.

Anyone know if this is possible?

Thanks.
DerekJ