Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: jmpoir on July 08, 2023, 12:28:08 PM
-
I have purchased Mach4vHobby and using a WXHC Ethernet Motion card. I have my X axis running with 2 stepper motors ,Motor0 with Motor 3 slaved .The issue i am having is when i jog the x drive the readout on the Mach4 is correct minus goes minus and plus goes plus. The issue is on the Table its moving to the right i need it to move to the left. Everything i tried with reversing the pulse on the card and in the Mach4 program nothing changes .
Any help would be appreciated
thanks
Joe
-
There must be a plugin for your motion controller, right? Although I don't see one for Mach4. If you have one for Mach4 the setting will likely be in the config for the plugin.
-
Thanks Tom i have looked in the config for the controller and there is a spot where is says to reverse the stepper motor and even though i do that nothing changes. So not sure if this needs to be changed in more than one spot .I will look again thank you for the reply.
Joe