Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jivac on July 07, 2023, 08:12:45 AM

Title: Work with pen
Post by: Jivac on July 07, 2023, 08:12:45 AM

Can I control the axle movement directly with the pen on the graphics display? Where and what settings should I ask? Thank you for your attention

Title: Re: Work with pen
Post by: Tweakie.CNC on July 07, 2023, 11:55:49 AM

Assuming you require accurate X and Y axis machine movement replicating the pen movement from a tablet…
There is no current facility for it to be done within Mach but it could be possible if the output from a graphics tablet was compatible with, just for example, the output from a CNC Pendant and suitable drivers were present.

Certainly an interesting possibility for anyone adept at writing the driver software plugin.

Tweakie.

Title: Re: Work with pen
Post by: Jivac on July 07, 2023, 01:57:39 PM

Thanks for the reply. I realized that the task was quite difficult.