Machsupport Forum

General CNC Chat => Building or Buying a Wood routing table.. Beginnners guide.. => Topic started by: JillB01 on May 30, 2023, 06:01:01 PM

Title: Start /stop spindle with software
Post by: JillB01 on May 30, 2023, 06:01:01 PM

Hello, I am new to this website, so go easy  please.
I  am looking to buy a 500W GRBL controller with a USB port to connect to my laptop. This will replace my old damaged controller. Problem is, there is no spindle stop/start switch or speed control knob.
Can anyone please advise any CAM software that will generate G.Code to do this ?  I  have been using Aspire to generate G.Code, but there is no stop/ start feature in that.
I  use UGS to run the control box

Title: Re: Start /stop spindle with software
Post by: Tweakie.CNC on May 31, 2023, 12:43:00 AM

Hi,

This forum relates to Artsoft / NFS products and Mach software in particular. Unfortunately GRBL and UGS are not supported.

Tweakie.