Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Fwibb on May 01, 2023, 01:28:42 PM

Title: Mach3 - Go to Zero at end of job went to +1in Y
Post by: Fwibb on May 01, 2023, 01:28:42 PM

I don't know what happened or how to prevent it. I did a job that I performed yesterday already and I knew it was programmed right. When I ran it just now everything went fine, EXCEPT that the end command of return to zero actually made the Y axis return to +1. Almost had a collision. What the hell happened and how do I prevent it?

Thanks!