Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Tristar500 on April 24, 2023, 10:53:14 PM

Title: Go to Zero and other things I miss about Mach 3
Post by: Tristar500 on April 24, 2023, 10:53:14 PM

I'm learning  Mach 4 after nearly 20 years with Mach 2/3.

Did the "Go to Zero button" vanish or maybe I'm just not looking in the right place?

also,
Is there a way to set up the keyboard jogs as automatic when starting Mach 4?

I have an I Mach Pendant (model P1AS)  I haven't connected it to my new machine (plasma cutter) Is there a way to enable it on bootup of Mach 4?

thanks in advance everybody! :-[

Title: Re: Go to Zero and other things I miss about Mach 3
Post by: joeaverage on April 25, 2023, 11:16:38 PM

Hi,
there is a GotoZero button, and there is a means of having the keyboard enabled on start up, and they have been discussed at length on this board within the last month,
some searching is warranted.

Craig

Title: Re: Go to Zero and other things I miss about Mach 3
Post by: joeaverage on April 25, 2023, 11:21:49 PM

Hi,

https://www.machsupport.com/forum/index.php?topic=44529.0 (https://www.machsupport.com/forum/index.php?topic=44529.0)

https://www.machsupport.com/forum/index.php?topic=47199.0 (https://www.machsupport.com/forum/index.php?topic=47199.0)

Craig