Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jchaplin on April 17, 2023, 10:32:31 AM

Title: Jog mode reverts to constant when reset button used.
Post by: Jchaplin on April 17, 2023, 10:32:31 AM

I have three machines running mach3 and one of them will revert the jog mode to constant any time either mach3 is restarted or the e stop is used manually on the controller or the reset button in the software.

Two of the machines remain on the jog mode you set it on forever unless you change it.  This is very annoying to me and I wonder.

Is there a setting for this in mach that I just  can't find?

Thanks,

John

Title: Re: Jog mode reverts to constant when reset button used.
Post by: Jchaplin on April 26, 2023, 03:12:50 PM

Bumping this issue hoping someone has an answer

Thanks,

John