Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: md12 on March 02, 2023, 02:46:36 PM

Title: Mach 3 Spindle not starting
Post by: md12 on March 02, 2023, 02:46:36 PM

I recently tested the E-stop on my CNC and after doing so, the spindle will not start up. I am trying to debug but getting stuck. When I initiate the spindle, I get the yellow light for the 1 second dwell and then a green blinking light in the spindle speed area of the Program Run page. When I look at the diagnostic page, I get a red blinking light in the output (#2) where the Spindle output is set. I'm not sure if the Estop test actually did anything to cause this issue, but it's the only change I can think of since the last time I ran a program on there.

Any feedback would be appreciated.

Title: Re: Mach 3 Spindle not starting
Post by: md12 on March 06, 2023, 03:55:12 PM

Adding images of the diagnostics and program run page

Title: Re: Mach 3 Spindle not starting
Post by: md12 on March 07, 2023, 11:17:35 AM

embarrassingly enough this was solved by unplugging the spindle power and plugging it back in.