Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: enzed on February 05, 2023, 09:51:40 AM

Title: Motor Tuning and Setup
Post by: enzed on February 05, 2023, 09:51:40 AM

I will appreciate it if someone can explain to me what is the function of "Step Pulse 1-5 us" and "Dir Pulse 0-5" in the Motor Tuning and Setup page, and what must these parameters be set to. I use Mach3 for plasma cutting. Thanks

Title: Re: Motor Tuning and Setup
Post by: Graham Waterworth on February 11, 2023, 08:33:23 PM

It is the pulse to pulse delay, most modern stepper drives are fine with this set to 1 older drives may need more, the higher the number the slower the axis can run.

Title: Re: Motor Tuning and Setup
Post by: enzed on February 11, 2023, 11:56:08 PM

Thank you for the explanation.